Beijer-electronics iX Panel K100 EN Bedienungsanleitung Seite 24

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 46
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 23
Hardware Replacement
8.4 ReplacingtheDisplay/Display
Cable
The following is needed:
A ne w display/display cable, see Available Spare Parts for iX Panel K100
AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the s teps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Disconnect the two ex cables the flex cable and the LED cable from the
power card and remove the two plastic nuts that hold the power card in place.
flex cables
plastic nut
plastic nut
4.
Lift the power card and gently remove
the backlight cables and the display
cablefromtherearsideofthepower
card.
5.
Remove the mounting plate (9 torx screws). Gently lift the mounting plate
with the display and power card.
9 x torx screws
BeijerElectronics, MAEN003
24
Seitenansicht 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare