Beijer-electronics AN-BEI-H2-038 Bedienungsanleitung PDF herunterladen (Seite 13)

APPLICATIONNOTEAN‐BEI‐H2‐038 Date:15/02/12



AN‐BEI‐H2‐038ModbusRTUControlandRegisterMapping

13



ModbusExceptionResponseTelegrams:

Undersomecircumstances,thedrivemayreplywithanExceptionResponse(error)inresponsetoarequesttelegramsentfrom

thenetworkmaster,forexamplewherethemastertriestoreadaregisterwhichdoesnotexist.ExceptionResponseswhichcan

begeneratedbythedrivearelistedbelow:‐



ExceptionCode1:InvalidRequest

Returnedunderthefollowingconditions

• NetworkMastersendsanunsupportedModbuscommand(e.g.ReadCoils).

• RuncommandissuedtodrivewhilstthedriveisnotsetforModbusControlMode(e.g.P1‐12<>4).

• Runcommandissuedtodriveswhilstthedriveis

notenabled(e.g.DigitalInput1isopen).

• Runcommandissuedtodrivewhilstthedriveisinatrippedcondition.



ExceptionCode2:InvalidModbusregister

Returnedunderthefollowingconditions

• NetworkMasterattemptstoreadorwritearegisterthatdoesnotexistwithinthedrive.



ExceptionCode3:RegisterValueOutofRange

Returnedunderthefollowingconditions

• NetworkMasterattemptstowriteaholdingregisterwithavalueoutsidetherangeoftheregister



ExceptionCode6:DriveBusy

Returnedunderthefollowingconditions

• Drivebusyduetointernaldatatransfer.

TheNetworkMastershouldre‐sendthemessageafteradelay



Dataflowexample:

Readdatafromregister6:



Request:[01] [03][00][05] [00][01][94][0B]

 (DriveAddr)(Command)(Regstartaddr)(No.ofRegisters)(Checksum)



Reply:[01] [03][02] [00][00][B8][44]

 (DriveAddr)(Command)(Noofdatabytes)(Data) (Checksum)



Note:Theactualstartaddressofregister

6is5.Alldatain[]isin8bitsHexformat.



Writestartcommandtotheregister1(supposeP‐12=3,P‐15=0anddigitalinput1isclosed):



Request:[01] [06][00][00] [00][01][48][0A]

 (DriveAddr)(Command)(Regaddr)

(Datavalue)(Checksum)



Reply:[01] [06][00][00] [00][01][48][0A]

 (DriveAddr)(Command)(Regaddr)(Datavalue)(Checksum)



Note:Theactualaddressofregister1onthedatalinkis0.Alldatain[]isin8bitsHexformat.

Replycanbeerrormessage

dependingondriveparametersettingsanddigitalinputstatus.



1 2 ... 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Beijer-electronics AN-BEI-H2-038 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Beijer-electronics AN-BEI-H2-038