Beijer-electronics iX Panel K60 EN Bedienungsanleitung Seite 22

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 45
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 21
Hardware Replacement
7.4 ReplacingtheDisplay/Display
Cable
The following is needed:
A new display including display frame, see
Available Spare Parts for iX Panel K60
AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the s teps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Foll ow the instr uctions under Replacing the Rear Cover to remove the rear
cover.
3.
Unlock the three flex c able connectors by pressing the conn ector flanges
towards the cable and disconnect the flex cables from the power card. The
connectors must be unlocked on both sides before removing the cables.
4.
Disconnect LED cable, if applicable.
power card
flex cables
LED (on some models)
5.
Gently press the power card towards the top of the panel as shown in the
illustration above to release the power card from th e power card hold ers. Then
tilt the bottom of the card away from you.
6.
Disconnecttheplaincableonthebacksideofthepowercardandremovethe
power card.
BeijerElectronics, MAEN001
22
Seitenansicht 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 44 45

Kommentare zu diesen Handbüchern

Keine Kommentare